5/21/2023 0 Comments Common tftpserver![]() Any existing DHCP server in the network cannot be used for Linux BMR NW based boot recovery. Please note that DHCP server needs to be configured on Linux BMR Boot server. The following is an example configuration: Have to define host information hosts are added and removed as needed by Modify the /etc/nf file to define the networks it serves.Edit the /etc/nf file and uncomment the tftp line.Enable the tftp service by doing the following:. ![]() Install the following RPM packages (unless they are installed already):.The following system prerequisites apply only to SUSE Linux systems: That it starts successfully by running the following command: To verify the /etc/nf file syntax, restart the daemon and ensure You do not have to define host information hosts are added and removed as needed by the BMR software. Create a /etc/nf file and configure it to define the networks it serves.Start the service by running the following command:.Edit the /etc/xinetd.d/tftp file and change disable = yes to disable= no.Install the following RPM packages (unless already installed):.The following system prerequisites apply only to Red Hat Linux systems: Redhat Enterprise Linux Network configuration.If the boot server is used only to create local SRTs for media based recovery, then above network services are not required to be setup. No /etc/exports configuration needs to be done manually BMR adds and removes specific export permissions as required during recovery time. etc/exports contain the filesystem entries which are exposed to other clients over NFS protocol. The NFS service must be available and nfsd daemon must be running. It must be uncommented and inetd needs to be refreshed for the BMR boot server to function. On some OS, this service is commented out of the /etc/nf file. Please follow below OS specific section for more details. Network services configurations on NetBackup BMR Boot Serverįor Network boot based recovery, NetBackup Bare Metal Restore (BMR) leverages OS specific NW boot protocols to boot client over BMR Boot Server and start recovery process.ĭifferent NW services like PXE, bootp, DHCP, TFTP, etc would need to be setup on BMR Boot server for NW boot recovery depending on the type of operating system platform.
0 Comments
Leave a Reply. |